Trusted Anti Backlash Ballscrew Kit For CNC Rigs With 25Mm Lead Screw And 380Mm Run Featuring Zero Play C7 Grade Engineering And Solid Bearing Mounts For Daily Shop Grind

One Piece CNC Ballscrew Kit With C7 Grade Mounts And 380Mm Run
✔️ 25Mm Shaft Ten Mm Pitch 380Mm Length Fourteen Mm Bore

This single package drops a complete anti backlash ballscrew assembly straight onto your bench. You swap out worn lead screws with a clean GCr15 steel unit that rides on zero play bearings. The three hundred eighty millimeter stroke covers eleven point eight inches of pure linear travel. It handles router tables, pick and place machines, and light automation rigs without skipping steps.

✅ Twenty five millimeter diameter (zero point nine eight inches) shaft with ten millimeter pitch (zero point three nine inches) for smooth tracking
✅ Three hundred eighty millimeter length (eleven point eight inches) total run for full axis coverage
✅ Fourteen millimeter bore (zero point five five inches) coupler fits standard stepper setups directly
✅ Deep groove bearing mounts handle radial loads while keeping axial play at zero
✅ Complete kit packs nut locknuts circlips and flex coupling out of the box

💡 When should you upgrade from standard lead screws to anti backlash ballscrews for CNC work?
Your rig runs smoother and stays handy under load when rolling elements replace sliding surfaces.
- Tightened preload eliminates slop so your X Y axes hit target coordinates dead on
- Lower drag means your stepper drivers do not fight hard and you can ramp up feed rates fast
- Sealed designs keep chips and dust out longer so maintenance intervals stretch way out
- Matching tolerances across the assembly keep vibration low on dense material passes

✝️