Top Shelf Needle Roller Thrust Bearing Washer Featuring A Precision 1.25 Inch Bore And Tough As Nails 1.937 Inch Outer Design Built For Heavy Duty Garage Swaps And Street Ready Power Delivery

Heavy Duty Needle Roller Thrust Bearing Washer
✔️ 1.25 Inch Bore 1.937 Inch OD 0.03 Inches Thick Center

You get a single needle roller thrust bearing washer built for serious shop work. It locks into drivetrain mounts to block sideways push during hard launches. This straightforward stackup saves you time and headaches when swapping out worn factory parts. You can run it straight on your daily driver or race setup without worrying about play.

✅ 1.25 inch center hole aligns perfectly with drive shafts
✅ 1.937 inch outer ring spreads weight across the mounting plate
✅ 0.03 inch low profile keeps clearance wide open for tight swaps

💡 What is a needle roller thrust washer typically used for in performance transmissions?
This flat steel disc takes the forward rush so gears stay locked under pressure.
- Catches heavy axial thrust while keeping shafts handy during aggressive shifts
- Absorbs sudden impact loads that would normally chew through old races
- Holds steady alignment when you floor it on sticky street tires

✝️