Top Drawer Flexible L Jaw Coupling Half Built Tough For Industrial Drive Systems Featuring Knockout Brass Design Optimized For Standard 3 4 Inch Bore And 3 16 Inch Keyway Fit

Brass L jaw coupling half for steady drive alignment in rigs.
✔️ Single piece includes 3/4 bore and 3/16 keyway with brass body.

You get this single L100 series flexible L jaw coupling half ready to handle vibration and misalignment on busy shop floors. The brass design mounts straight onto your motor or pump shaft to keep torque transferring cleanly through conveyors, blowers, and compressors.

✅ 3/4 inch bore seats cleanly on standard round shafts
✅ 3/16 inch keyway stops rotational drift under heavy loads
✅ Two set screws bite into the shaft for fast bench mounting
✅ Outside diameter spans 2-1/2 inches for tight equipment bays
✅ Assembled length hits 3-1/2 inches for compact drive trains

💡 What makes a flexible L jaw coupling half so handy for smoothing out vibration in industrial motor drives?

Keeping your power link intact takes the wear off expensive bearings.

- The replaceable resin spider eats up shock peaks and stops metal contact

- Hardened brass halves slide heat away while holding steady torque angles