Real Deal Front And Rear Wheel Bearing And Hub Assembly Kit For Nissan Altima Fwd Comes With Built In Abs Sensor 5 Stud 4 Hole Flange Heavy Duty Build Straight Swap No Sweat Install

Front Rear Wheel Bearing Hub Kit For Nissan Altima FWD
✔️ Five stud configuration four mounting holes plus ready for ABS hookup

You get a complete set of four premium wheel bearings and hubs paired right upfront for your Nissan Altima. This direct swap kit replaces worn out rotating parts that cause humming noises or loose steering feel. Install it quickly on front wheel drive sedans to restore solid handling and smooth tire roll. Stop guessing which seal goes where since everything mounts directly without extra brackets.

✅ Front flange measures 136 mm (5.35 inches) with modified shape clearance
✅ Rear flange spans 148 mm (5.83 inches) to match factory stamped edges
✅ Two nine spline shaft connects smoothly to your front drive axle units
✅ Sixty eight mm (2.68 inches) brake pilot centers rotors dead straight
✅ Five stud rim pattern pairs with four hole mounting face perfectly

💡 What actually causes premature failure in modern street vehicle bearing setups?
Grime sneaks through thin metal shields and scrapes precision raceways daily.
- Upgraded sealed cartridges trap zero dust while keeping high temp grease locked tight
- Matching spline counts and bolt circles saves countless weekend garage headaches
- Installing a handy aftermarket assembly restores crisp road feedback without guesswork