Bulletproof 12 Piece Upper And Lower Intake Manifold Gasket Set For Dodge Chrysler Jeep Ram 3.6L V6 Heavy Duty Rubber Seal Kit Workhorse Replacement 5184331AC 5184562AC
✔️ Compatible with 3 6 L V6 Dodge Chrysler Jeep Ram motors
This twelve piece seal kit swaps out worn intake manifold gaskets on popular North American trucks. You get every ring and tab required to reseal the plenum securely. Old rubber cracks fast under heat and causes frustrating vacuum loss on your 3 6 liter V6.
✅ Six upper seals measure 2 56 by 1 60 by 0 24 inches for perfect width coverage✅ Six lower gaskets wrap tightly around the carburetor inlet tubes
✅ Heavy grade rubber stays flexible when exhaust gases hit boiling levels
✅ Factory approved cuts align smoothly with stock bolt patterns
💡 Why is a handy intake manifold gasket swap necessary for older trucks?
Worn rubber seals let unmeasured air sneak past the combustion chamber. This messy leak messes up the air fuel ratio and drops your gas mileage quick. Swapping the gaskets brings the vacuum system back on track immediately. Here is why this handy upgrade pays off fast:
- Tight valve seating stops rough idle and kills that pesky check engine signal
- Smooth air routing pushes clean mixture straight through the cylinder head passages
- Heat resistant material survives baking temperatures without shrinking or cracking apart
- Straight bolt on setup lets you finish the repair hands down without expensive shop fees