Built Tough 1/20 Hp Refrigeration Fan Motor 1550 RPM 208-230 Volt Single Phase Shaded Pole Type Clockwise Spin With Extended Stud Mount And 5 16 Shaft To Keep Coolers Humming Smoothly While You Kick Back Relaxing

Single Pack 1/20 HP Refrigeration Fan Motor For Cold Storage
✔️ Single 1/20 HP cold room fan motor built for steady commercial cooling

This single replacement unit keeps evaporative coolers and walk-in chillers running steady during peak summer shifts. You swap the worn out part quickly because it mounts straight onto extended studs and fits sealed display cases. Reliable airflow means your merchandise stays fresh without guesswork or extra heat buildup.

✅ Half twentieth horsepower output handles full load duty cycles
✅ Sleeve bearings run quiet over open air frames for long service life
✅ Five sixteenths inch drive shaft aligns with standard pulley hubs
✅ Three point three inch body diameter drops right into existing brackets
✅ Clockwise spin direction locks perfectly with original compressor vents

💡 What makes shaded pole motors handy for commercial cooling projects?
This direct wired design saves time when you replace failed components overnight.
- Simple wiring paths cut down installation headaches on tight electrical frames
- Open coil builds handle dust loads better than sealed industrial alternatives
- Predictable ramp up speed protects older refrigerator compressors reliably

✝️