1-1/4 Inch Three Bolt Flange Bearing Cast Iron Housing With Grease Zerk And Dual Set Screws Heavy Duty Pillow Block Drop In Replacement Swap For SBTRD206-20g Rugged Workhorse Unit

Heavy duty 1-1/4 inch pillow block bearing assembly
✔️ Cast iron housing grease zerck and dual set screws for shaft

You run heavy equipment that needs steady shaft support. This single pillow block bearing drops straight into machine frames rollers and conveyor drives. Its tight tolerance rings cut down vibration so your motors hum along. Pop this swap in place and finish the job clean.

✅ 1.25 inch (31.75mm) bearing bore aligns perfectly with standard shafts
✅ Mounting centers rest at 3.08 inches (78.34mm) apart for precise alignment
✅ Solid overall reach sits at 3.56 inches (90.48mm) thick for sturdy support
✅ Plate depth measures 1.34 inches (34.13mm) wide to fill standard footprints
✅ Fastening slots take 3/8 inch (9.52mm) bolts for rock solid floor mounting
✅ Direct swap match for Peer Ami Browning Dodge and Fafnir part lists

💡 Why choose cast iron pillow block bearings for high torque conveyor drives?

These sealed units solve shaft misalignment on tough factory floors.

- Rugged iron cases absorb shock and protect inner rings from grime.

- Pre-laced races roll smooth through demanding motor cycles daily.

- Easy grease zercks save downtime by letting you reload lubricant fast.

✝️