Three Pack 180Mm Vertical Floating Switch For Liquid Water Level Monitoring And Tank Fluid Control With Solid Direct Current Specs For A No Sweat Diy Plumbing Setup

3-Pack 180mm Vertical Float Switch for Tank Fluid Level Control
✔️ SUS304 body, 180mm length, 10mm thread, 0.5A max load needs relay

You need a dependable way to track fluid levels in your sump or storage tank without pulling wires everywhere. This 180 mm straight float switch mounts vertically on a pipe and drops into your vessel to read water height. Plumbers and hobbyists rely on these units in aquariums, rain barrels, drainage pits, and irrigation reservoirs. The sealed SUS304 shaft keeps out moisture while the built-in magnetic reed contacts send clean signals to control pumps. You get three switches so you can stock replacements or run multiple circuits at once.

✅ Max switching voltage hits 100V DC with 220V breakdown protection
✅ Contact resistance stays tight below 100m Ohms under load
✅ Temperature tolerance handles environments from -30 to 120 C
✅ Overall assembly reaches 180mm / 7.1 inch outside threaded zone
✅ Thread diameter measures 10mm / 0.39 inch spanning 15mm grip
✅ Integrated cord stretches 34cm / 13.4 inch for straightforward runs

💡 What is a vertical water level float switch used for in DIY tank setups?
You get reliable liquid monitoring without complex wiring headaches.
- Monitors fluid depth up to 180 mm / 7.1 inch inside straight containers
- Sends low current signals to external relays for pump triggers
- Handles steady flow in rain collection bins and drain pits
- Works handy around damp workshops and outdoor storage sheds