Workhorse Vertical Float Switch Crafted From Heavy Duty Stainless Steel Featuring A Seven Five Millimeter Rod For No Sweat Liquid Level Management Across Aquarium Ponds And Storage Cisterns
✔️ Single stainless switch, 28mm float, 75mm stem, 220V DC, compact shell
This single stainless steel float switch manages fluid heights inside aquariums, garden ponds, or storage cisterns. You mount it vertically to trigger pumps exactly when water drops below set marks. The tight twenty eight millimeter (one point one inch) profile slides into crowded racks without blocking access. A seventy five millimeter (three inch) stem reaches deep into drainage lines. Sealed laser welding keeps humidity away from sensitive contacts during daily cycling.
✅ Heavy duty aluminum body fights rust across outdoor cistern and pool setups✅ Simple spring swap flips the switch between normally open and normally closed states
✅ Rated for one hundred twenty degree C heat and two point five MPa pressure during busy irrigation cycles
✅ Two wire leads plug straight into solenoid drivers without extra relays
✅ Ships fully assembled and ready for direct top or bottom installation
💡 Why pick a heavy duty automatic liquid level monitor for outdoor reservoirs?
This handy sensor reads water depth continuously so your pumps activate automatically before dry runs happen.
- Magnetic reed contacts inside prevent arcing when switching high amp loads on suddenly
- Solid stainless casing blocks salt and chemical damage from treated pool or well water
- Quick orientation change adjusts the cutoff point whether you mount it upright or upside down
- Direct wiring cuts down on messy junction boxes while saving time during weekend DIY jobs