Precision Taper Cutting Jig Featuring Rugged Aluminum Guide Bars and Heavy Duty Push Handle for Dead Nuts Angled Cuts Up to Fifteen Degrees or Three Inches per Foot Built Tough for Zero Hassle Woodshop Projects

Heavy duty tapered woodworking jig for sharp angles
✔️ Aluminum rails, 2-5/8 inch grip, accurate 15 degree cuts

This single taper cutting jig mounts directly to your table saw to deliver clean slanted edges on hardwood stock. You eliminate setup guesswork and lock in consistent measurements before every rip pass.

✅ Heavy aluminum guide rails keep your board stable while the blade bites
✅ 2-5/8 inch push handle puts solid leverage in your hands during heavy cuts
✅ Integrated graduation dial tracks both percentage rise and exact angle readings

💡 How do you set up a taper cutting jig for accurate angled runs?
Grab a handy method that keeps your timber square while the motor spins.
- Clamp the steel base plate firmly against the front fence rail
- Align the sliding track until the index hits your target percent slope
- Feed the lumber through steadily while pushing down on the guide grip
- Swap out the wedge stops whenever you need fresh dimensions next week

✝️