1/4 Inch Round Flush Unthreaded Pilot Pin Grade 400 Stainless Steel Self Clinching Fastener 0.750 Inch Length Heavy Duty Industrial Tooling Precision Drop Dead Accurate Fit Pack Of 10
✔️ 1/4 inch round head grade 400 steel industrial tooling pins
You grab these alignment rods to stack sheet metal accurately during assembly. You drive them straight into stamped holes without worrying about threaded grips. Your fresh fixture board stays dead flat while you run drills or welders over the edges.
✅ 0.25 inch diameter rounds out clean stamped holes every time✅ 0.75 inch body length seats flush against stacked metal sheets
✅ Works reliably on panels down to four thousandths thick
✅ Unthreaded stainless construction wipes clean after heavy welding days
✅ Gray oxide coating protects your fingers from sharp burrs
💡 What makes self clinching pilot pins handy for laying out metal stacks.
A solid guide rod saves you from guessing hole placement when you clamp raw plate. Just punch the initial mark and drive the pin home for instant repeatability.
- Stamped holes grip the tapered shank tight so panels wont shift under drill pressure
- Flush mounting heads let you slide measuring tapes across the work surface without snagging
- Heat resistant builds stay accurate even after repeated MIG weld runs nearby
- Standardized cross sections fit most vise plates and fixture boards out of the box