Heavy Duty Two Piece Vertical Ball Float Switch For Liquid Water Level Sensing Built Tough For Wet Environments With No Sweat Installation And Top Shelf Reliability Designed To Keep Running Smoothly Under Pressure All Day Long
✔️ SUS304 unit, 10mm 0.39in bolt, 120mm 4.7in rod, 34cm wire, 0.5A max
A handy vertical ball float switch helps you track fluid levels inside tanks or sump pits. This sensor works well in irrigation systems, water storage bins, and industrial fluid setups. You get a pack of two sleek units right out of the box. The solid stainless shell handles damp corners without rusting out. Mount it upright where you need steady monitoring.
✅ Max switching voltage hits 100 volts dc✅ Handles up to 0.5 amps without frying circuits
✅ Stainless steel housing runs 120mm long 4.7 inches
✅ Base threading offers a 10mm diameter 0.39 inch width
✅ Standoff nut depth stays tight at 15mm 0.59 inches deep
✅ Attached wire stretches 34cm out 13.4 inches total
💡 How does a sealed vertical ball float switch maintain accurate water level sensing across varying tank pressures?
Picking the right float switch comes down to matching your electrical load and mounting orientation properly.
Match the rated voltage to your pump controller before wiring anything together
Install the unit vertically so the internal sphere moves freely inside the guide tube
Pair the zero point five amp contacts with an external relay for heavy equipment
Check seal integrity when submerging stainless steel components into alkaline fluids