Heavy Duty Marine Fuel Sending Unit 0 190 Ohm 17 72 Inch Stainless Steel Tank Gauge Sensor For Boat Truck And Rv Featuring A No Sweat Swap Design Rock Solid Readings And Built Tough For Daily Grinds

Heavy duty marine fuel sending unit for single boat and truck tanks
✔️ 316 stainless steel housing reads 0-to-190 ohms precisely

Saltwater and road grime kill cheap gauges fast. You need a sensor built for daily runs. This handy piece fits right into your boat, truck, RV, generator, or chemical tank setup. You get a single heavy duty marine fuel sending unit that tracks liquid levels without guessing.

✅ IP67 sealed casing shuts out moisture and spray
✅ SAE compatible five hole mount cuts wiring time down
✅ Custom shaft lengths run from 150 millimeters to 600 millimeters plus six to twenty four inches
✅ One year warranty covers every measurement drift

💡 How do you wire a heavy duty tank level sender for accurate cruise tracking?

You connect the resistance probe to your existing dashboard gauge in minutes.
- Calibrate the zero to one hundred ninety ohm signal to match your dash panel exactly
- Keep an inch gap below plastic hull bottoms and half an inch off metal deck plates
- Run the red lead straight to ignition power while grounding the blue cable firmly
- Use the heavy duty mounting hardware to lock everything tight against vibration✝️